Specifications
General Information
This section tells you how to change your password. It also provides
information that you should share with all system users and other information
that is specifically for the receptionist at extension 10.
Changing Your Password
The factory setting for login 99’s (the System Manager’s) password is 1234. You
should change the default password immediately after installation or any time
the password has been reset to prevent unauthorized programming of the
system. You can assign up to four digits for a password. As a safeguard
against toll fraud, it is recommended that you create a password from random,
non-sequential digits.
If you change the password and forget it, you must contact the AT&T Helpline at
1 800 628-2888 or an AT&T Authorized Dealer for instructions on how to reset
the password.
To change the password for login 99:
1.
2.
3.
4.
5.
6.
7.
Press [
Intercom
] [
7
] [
7
] [
7
] or a programmed button.
Press [
9
] [
9
] [
#
].
Enter the existing password (for example 1234) and press [
#
].
Press [
5
] to change the password.
The prompt asks you to enter your new password.
Enter up to four digits for the new password and press [
# ].
The prompt asks you to re-enter your new password.
Enter your new password again followed by [
#
].
The new password is now active.
Hang up to quit.
Training Co-Workers
Using the Tutor Service
The Tutor Service is an “on-line help” feature that allows all system users (not
just voice messaging system subscribers) to easily access and listen to
information on commonly-used communications system features. You should let
system users know about this service and recommend that users stick the Tutor
Service label (provided with the voice messaging system hardware) into the
depression for the handset mouthpiece on the base of their system phone.
5-2 System Management