Specifications

Call Answer Service
Before you begin, locate Form A and Form B2 of the System Planner for the
Communications System. Refer to Form A, item 7, Line Coverage, to see if any
lines are designated “VMS–MAlL.” If so, use this section to program Call
Answer Service. If not, skip to “Telephone Button Programming.”
CO Line Coverage
To assign “VMS-MAIL” lines specified on Form A, item 7, Line Coverage, to Hunt
Group 7:
1.
Press [ # ] [ 2 ] [ 0 ] [ 6 ].
2.
At the Group: prompt, press [ 7 ].
3.
At the Line: prompt, enter the first “VMS-MAIL” line specified in the Line
Coverage column of Form A, item 7.
4. Press [ Next Data ] until the display reads 3 VMS Line Cover.
5.
To program another line, press [ Next Item ] or [ Prev Item ] until the appropriate line
number displays. Then press [
Next Data ] until 3 VMS Line Cover
displays.
6.
Continue with “Automatic VMS Cover” below.
Automatic VMS Cover
Use this procedure to assign automatic voice mail coverage to the appropriate
extensions.
To change the Automatic VMS Cover setting for an extension to Assigned as
indicated on Form B2:
1.
Press [
# ] [ 3 ] [ 1 ] [ 0 ].
2.
Enter the number of the first extension to which Automatic VMS Cover is to be
Assigned.
3.
Press [ Next Data ] until 1 Assigned shows on the display.
4. To program another extension, press [ Next Item ] or [ Prev Item ] until the extension
number shows on the display. Then repeat Step 3.
5.
Press [ Feature ] [ 0 ] [ 0 ] to exit programming mode.
6.
Continue with the next section, “Telephone Button Programming.”
Initial Programming
4-9