Specifications

After approximately 10 seconds when the tests are completed, the yellow Test

LED goes off. When this occurs, check the red Status LED:

■

If the red Status LED is not lit, the module passed the tests. Continue

with Step 8.

■

If the red Status LED is lit, power down the control unit, re-install the

Mailbox Expansion Card if it was installed in Step 4, then power up the

control unit again. If the red Status LED comes on again, call the

Helpline.

After the module passes the self-diagnostic tests, the two extensions

associated with the voice messaging system module go off-hook. The two

lines show red steady for about 1 minute. When the lines become idle, the

voice messaging system is ready to receive calls.

Installation

2-5