Specifications

Install the voice messaging system module in the first available slot to the right

of the last installed 206 or 400 module. Do not install the voice messaging

system module in the first slot of the PARTNER Plus system control unit or

the PARTNER

system primary carrier.

NOTE:

The voice messaging system module should always be installed after the

206 and 400 modules to ensure consecutive extension numbering. If the

control unit is upgraded with more 206 or 400 modules, the voice

messaging system module should be removed, the new modules should

be installed, and the voice messaging system module should be replaced

in the first available slot after the 206 and 400 modules. Reprogram the

VMS Hunt Group Extensions and Transfer Return Extensions (page 4-2).

a. Press the locking tab on the bottom of the slot as you push in the

module. Align the dovetail guides on the sides of the module with the

guides on any previously inserted modules.

b. Push slowly but firmly until the module locks into place with two snaps,

and is attached to the rear of the backplane and held in place by the

locking tab. Do not force the module. If it does not insert easily, remove

the module, clear any obstruction, and reinsert it.

Refer to Figure 2-2, then record the two extensions associated with the voice

messaging system module in the System Planner.

PARTNER Plus Control Unit or

PARTNER II Primary Carrier

PARTNER II Expansion

Carrier Only

If PARTNER MAIL VS

Is Installed In Slot:

1 2

Then Assign These

Exts. To Hunt Group 7:

20,21

26,27 32,33

38,39

44,45

50,51

56,57

Figure 2-2. Voice Messaging System Extensions

Installation 2-3