User Manual
Table Of Contents
- Getting started
- Installation options
- Initial setups
- Battery installation and charging
- Telephone base and charger installation
- Quick reference guide - telephone base
- Quick reference guide - handset
- Telephone settings
- Telephone operation
- Directory
- Caller ID
- Smart call blocker
- Answering system
- Answering system settings
- Announcement
- Answer on/off
- Voice guide
- Call screening
- Number of rings
- Remote access code
- Message alert tone
- Message recording time
- Answering system and voicemail indicators
- Using the answering machine and voicemail together
- Message capacity
- Voice prompts
- Call screening
- Call intercept
- Base ringer
- Temporarily turning off the message alert tone
- Message playback
- Recording and playing memos
- Base message counter displays
- Remote access
- Answering system settings
- Appendix
- Adding and registering handsets/headsets/speakerphones
- Deregistering handsets
- Alert tones and lights
- Screen display messages
- Troubleshooting
- Maintenance
- Important safety information
- FCC Part 68 and ACTA
- FCC Part 15
- California Energy Commission battery charging testing instructions
- Limited warranty
- Technical specifications
- Index
Appendix
138
PB
Troubleshooting
Reset the telephone base. Unplug the electrical power. Wait for
15 seconds, then plug it back in. Allow up to one minute for the
cordless handset and telephone base to reset.
Other electronic products such as HAM radios and other DECT
phones, can cause interference with your cordless phone. Try
installing your phone as far away as possible from these types of
electronic devices.
The batteries do not hold a charge.
If the cordless handset is in the telephone base or charger and
the charge light is not on, refer to The charge light is o
(page 141).
Charge the battery in the cordless handset for at least ten hours.
For optimum daily performance, return the cordless handset to
the telephone base or charger when not in use.
If the battery is depleted, it may take approximately 30 minutes
to charge the handset before it shows Low battery. Refer to the
table on page 9 for details.
You may need to purchase a new battery. Please refer to
Battery installation and charging in this user’s manual on
pages 9-11.