User Manual
Table Of Contents
- Getting started
- Installation options
- Initial setups
- Battery installation and charging
- Telephone base and charger installation
- Quick reference guide - telephone base
- Quick reference guide - handset
- Telephone settings
- Telephone operation
- Directory
- Caller ID
- Smart call blocker
- Answering system
- Answering system settings
- Announcement
- Answer on/off
- Voice guide
- Call screening
- Number of rings
- Remote access code
- Message alert tone
- Message recording time
- Answering system and voicemail indicators
- Using the answering machine and voicemail together
- Message capacity
- Voice prompts
- Call screening
- Call intercept
- Base ringer
- Temporarily turning off the message alert tone
- Message playback
- Recording and playing memos
- Base message counter displays
- Remote access
- Answering system settings
- Appendix
- Adding and registering handsets/headsets/speakerphones
- Deregistering handsets
- Alert tones and lights
- Screen display messages
- Troubleshooting
- Maintenance
- Important safety information
- FCC Part 68 and ACTA
- FCC Part 15
- California Energy Commission battery charging testing instructions
- Limited warranty
- Technical specifications
- Index
Answering system
119
Message playback
Options during playback
When a message is playing, you can adjust the playback volume,
skip, repeat, pause or delete the message.
When messages are playing on the telephone base:
Press VOLUME+ or VOLUME- to adjust the message
playback volume.
Press /SKIP to skip to the next message.
Press /REPEAT to repeat the message. Press twice to hear the
previous message.
Press X/DELETE to delete the message.
Press /PLAY/STOP to stop the playback.
When messages are playing on the handset:
Press CID/VOLUME or DIR/VOLUME to adjust the message
playback volume.
Press 6 to skip to the next message.
Press 4 to repeat the message. Press twice to hear the previous
message.
Press MUTE/DELETE to delete the message.
Press 5 or to stop the playback.
Press /SPEAKER to switch between speakerphone mode and
handset mode.
Press to stop playback. The screen shows
Call back?, then press MENU/SELECT or to call
back the caller if the caller’s number is available. If the dialing
format used is not correct, then use the following option to
choose the correct dialing format before calling back the caller.
Press MENU/SELECT to pause playback and show the caller ID
information if available. From here, you can press
to resume playback, or press # (pound key) repeatedly to show
the desired dialing option (page 63), then press MENU/SELECT
or to call back the caller. If you do not call back
within ten seconds, message playback resumes automatically.