User Manual
Table Of Contents
- Getting started
- Installation options
- Initial setups
- Battery installation and charging
- Telephone base and charger installation
- Quick reference guide - telephone base
- Quick reference guide - handset
- Telephone settings
- Telephone operation
- Directory
- Caller ID
- Smart call blocker
- Answering system
- Answering system settings
- Announcement
- Answer on/off
- Voice guide
- Call screening
- Number of rings
- Remote access code
- Message alert tone
- Message recording time
- Answering system and voicemail indicators
- Using the answering machine and voicemail together
- Message capacity
- Voice prompts
- Call screening
- Call intercept
- Base ringer
- Temporarily turning off the message alert tone
- Message playback
- Recording and playing memos
- Base message counter displays
- Remote access
- Answering system settings
- Appendix
- Adding and registering handsets/headsets/speakerphones
- Deregistering handsets
- Alert tones and lights
- Screen display messages
- Troubleshooting
- Maintenance
- Important safety information
- FCC Part 68 and ACTA
- FCC Part 15
- California Energy Commission battery charging testing instructions
- Limited warranty
- Technical specifications
- Index
Answering system
109
Answering system settings
Number of rings
are no new messages. This feature allows you to check for new
messages and avoid paying long distance charges when calling from
out of your local area. By default, the answering system answers an
To set the number of rings:
1. When the handset is in idle mode, press
MENU/SELECT to enter the main menu.
2. Press CID or DIR to scroll to Answering sys,
then press MENU/SELECT.
3. Press CID or DIR to scroll to Ans sys setup,
then press MENU/SELECT.
4. Press CID or DIR to scroll to
#
of rings, then
press MENU/SELECT.
5. Press CID or DIR to choose among 2, 3, 4, 5, 6
or Toll saver.
6. Press MENU/SELECT
tone.
Notes:
If you subscribe to voicemail service through your telephone service provider, see Answering
system and voicemail indicators on page 113.
If you set the number of rings for the answering system as two or three rings, the caller ID
announce feature may not have enough time to announce the caller’s full information.
If Smart call blocker is on, the first ring of all incoming calls will be muted.
Call screening
># of rings
# OF RINGS
>4