User Manual

Answering system
107
Answering system settings
Voice guide
This feature is an alternative way for you to do the basic setup of
the answering system. You can follow the voice guide to record
your own announcement, set the number of rings, and set the
message alert tone.
This feature is only available on the cordless handset.
1. Press MENU/SELECT on the handset when it is not
in use.
2. Press CID or  to scroll to Answering sys, then
press MENU/SELECT.
3. Press CID or DIR to scroll to Voice guide, then
press MENU/SELECT. You hear a voice prompt,
“This voice guide will assist you with the basic
setup of your answering system.“
4. Setup your answering system by inputting
designated numbers, as instructed in the voice
guide.
Notes:
 You can press OFF/CANCEL to quit the voice guide at any time.
 If the system does not receive any input, it will announce “Sorry, I still have not received any input.
If you want to restart the voice guide, please enter the menu and select Voice guide under Answering
system. Good bye.”
 After a power outage, the handset prompts you to set the date and time, and Smart call blocker.
After these settings are done or skipped, the handset prompts if you want to set up the answering
system via voice guide. Press MENU/SELECT to start the setup.
 If the answering system is off and there is an incoming call, the system answers after ten rings and
announces, “Please enter your remote access code.” For more information about remote access, see
page 123.
Play messages
>Answering sys
Answer ON/OFF
>Voice guide
Setting up
Answering sys...