User manual

87
RF Exposure Information (SAR)
This mobile phone meets the government’s requirements for exposure to
radio waves. This phone is designed and manufactured not to exceed
the emission limits for exposure to radio frequency (RF) energy set by the
Federal Communications Commission of the U.S. Government. The exposure
standard for wireless mobile phones employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6 W/
kg. Tests for SAR are conducted using standard operating positions accepted
by the FCC with the phone transmitting at its highest certified power level in
all tested frequency bands.
Although the SAR is determined at the highest certified power level, the
actual SAR level of the phone while operating can be well below the
maximum value. This is because the phone is designed to operate at multiple
power levels so as to use only the power required to reach the network. In
general, the closer you are to a wireless base station, the lower the power
output.
The highest SAR value for the model phone as reported to the FCC when
tested for use at the head is 1.16 W/kg and when worn on the body, as
described in this user guide, is 1.58 W/kg (Body-worn measurements differ
among phone models, depending upon available accessories and FCC
requirements.
While there may be differences between the SAR levels of various phones and
at various positions, they all meet the government requirement.
The FCC has granted an Equipment Authorization for this model phone with
all reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model phone is on file with the FCC and
can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid
after searching on FCC ID: RYQEA211101.
For body worn operation, this phone has been tested and meets the FCC
RF exposure guidelines for use with an accessory that contains no metal