Troubleshooting guide

172 Avaya CMS Supervisor Report Designer
Data Labels tab
Use the Data Labels tab to define where the labels of each data point on the chart will be
displayed and to define how the labels will be displayed.
Example
Data Labels tab options
You can specify the following parameters:
● None - No labels are displayed.
● Above Point - The label is displayed above the data point. This location is valid only for
bar, line, area, and step charts.
● Below Point - The label is displayed below the data point. This location is valid only for
bar, line, area, and step charts.
● Center - The label is displayed centered on the data point. This location is valid only for
bar, line, area, and step charts.
● Base - The label is displayed along the category axis, directly beneath the data point.
This location is valid only for bar, line, area, and step charts.
● Inside - The label is displayed inside a pie slice. This location is valid only for pie charts.
● Outside - The label is displayed outside a pie slice. This location is valid only for pie
charts.