Instruction manual

Using reports
56 Issue 3 July 2001 Send feedback: [e-mail]
Some of the defaults for the system printer are set when the
system is installed. If you make any changes to your system
configuration, you may need to change the system parameters for
the reports to print accurately.
Let’s set the parameters for the EIA port. (Note that G3R cabinets
do not have EIA ports.)
To set system parameters:
1. Type
change system-parameters features and press
RETURN.
The Feature-Related System Parameters screen appears.
2. In the System Printer Extension field, type
eia.
NOTE:
If you’re connecting to a data module instead of EIA, type
the extension for the data module.
3. In the Lines Per Page field, type the number of lines per
page.
For our example, leave the default of
60 in this field.
4. In the EIA Device Bit Rate field, type
9600.
NOTE:
If you are connecting to a data module instead of EIA, the
data module controls the speed.
5. Press ENTER to save your changes.
Tip:
Check frequently to ensure that the system printer has enough
paper. Reports lost to printer failure cannot be recovered.
For more information, refer to DEFINITY ECS Reports.