Instruction manual

Adding trunk groups
Issue 3 July 2001
5Send feedback: [e-mail]
trunks
To add a new trunk-group:
1. Type
add trunk-group next and press RETURN.
The Trunk Group screen appears.
The system assigns the next available trunk group number
to this group. In our example, we are adding trunk group 5.
Trunk Group screen
2. In the Group Type field, enter the type of trunk you want
to add.
In our example, enter
co, which is also the default.
If you select a different trunk type, such as DID, the
system changes the screen to show only those fields that
apply to the type of trunk-group you are adding.
TRUNK GROUP
Group Number: 5 Group Type: co CDR Reports: y
Group Name: outside calls COR: 1 TN: 1 TAC:647
Direction: two-way Outgoing Display? n
Dial Access: n Busy Threshold: 99 Night Service: 1234
Queue Length: 0 Country: 1 Incoming Destination: ____
Comm Type: voice Auth Code? n Digit Absorbtion List: ____
Prefix-1?: y Trunk Flash? n Toll Restricted? y
TRUNK PARAMETERS
Trunk Type: loop start
Outgoing Dial type: tone Cut Through? n
Trunk Termination: rc Disconnect Timing(msec): 500
Auto Guard?: n Call Still Held? n Sig Bit Inversion: none
Analog Loss Group: Digital Loss Group:
Trunk Gain: high
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 10 Receive Answer Supervision? n