User`s guide

Administering Announcements
Your CMS supports up to four voice announcement units for providing delay
messages to callers.
The voice announcement units are connected to System
25 ports and have PDCs associated with them.
To administer voice announcement units, press [F7] (labeled “Admin Anncs”)
on the Administer Line Groups screen. The Administer Announcement
screen, shown below, appears.
ADMINISTER ANNOUNCEMENT
ADMIN CMS1.0 2:57p 04/18
PDC
F10 - Help
F Add F Remove F Change
F Assign F Admin
F Admin
l Annc 2 Annc 3 Annc
6 Anncs 7 lineGrps 8 Menu
ADMINISTER ANNOUNCEMENTS
ANNC ID
PORT#
1 PUBLIC
10802
2
BUSINES
10803
3
CHARTER 10804
4
610
611
612
With this screen you can:
●
●
●
●
Add an announcement unit by entering its announcement ID, System 25
port number, and PDC
Remove an announcement unit
Change the information (announcement ID, port number, or PDC)
pertaining to an announcement unit
Access the screen used to assign announcements to line groups, specify
the message length of each announcement unit, and put an
announcement unit in or out of service
You can return to the Administer Line Groups screen or Administration
Menu from the Administer Announcement screen by pressing [F7] or [F8] ,
respectively.
NOTE: The following require System 25 administration:
– Adding a voice announcement unit
– Removing a voice announcement unit
– Changing the PDC or port number of a voice announcement unit
Administering CMS Lines and Line Groups 4-19