User`s guide

Installing the CMS Software
COPYING THE CMS
SOFTWARE ONTO THE
PC’S HARD DISK
Installing the CMS software involves copying the contents of the working
copies of the two CMS diskettes onto the PC’s hard disk. This was done
when CMS was first set up for you.
As part of the installation procedure, a
CONFIG.SYS and an AUTOEXEC.BAT file were placed on your PC’s hard
disk. If these files existed prior to CMS installation, the installation procedure
edited these files. See “The CONFIG.SYS File” and “The AUTOEXEC.BAT
File” later in this section.
You can perform the following software procedures tore-install the CMS
software if errors occur that you cannot fix and you need to begin again.
When you are finished, the system will have copied the programs required
for CMS operations onto the ‘PC’s hard disk.
-
— —
1
2
3
To copy the CMS software onto the PC’s hard disk:
Insert the diskette labeled “SYSTEM 25 CMS SYSTEM WORKING COPY”
into drive A.
At the C> prompt, type a:\cmsinstall and then press [Enter].
.
The following messages appear in the upper portion of the screen and
remain on the screen throughout the installation procedure:
**** SYSTEM 25 Call Management System
**** Installation Procedure
Additional messages appear in the lower area of the screen.
While the installation procedure is in progress, the following message
usually appears on your screen:
**** Installation Now In Progress. Please Wait...
However, there are a couple ways in which the installation procedure
could be interrupted:
— If there are errors on your CMS working copy diskette that prevent
the installation program from continuing, the following messages
appear on the screen:
**** ERROR on Installation Floppy Disk
Try installation from Another Floppy
Discard the diskette, make another working copy using the original
CMS diskette, and then begin the CMS software installation procedure
again.
—
If there is insufficient storage space on the hard disk for new
information, the following messages appear on your screen:
**** “Insufficient Disk Space for CMS.
An Additional xxxK is Required.
Delete Old Files and Try Installation Again.
If you need directions on using the MS-DOS “delete” (del) and
“directory” (dir) commands to delete files, see the user’s guide that
came with the MS-DOS diskette.
Installing the CMS Software 3-5