User`s guide

4 When you are ready, press any key.
The in-use light on disk drive A comes on while the system is reading the
source diskette.
5
6
7
8
9
WARNING
Do not remove a diskette from the drive while the
in-use light is on; data on the diskette may be
damaged or lost.
When the system has read the diskette, the following messages are
displayed:
Insert TARGET diskette in drive A:
Strike any key when ready. . .
When the in-use light on drive A is off, remove the source diskette, insert
a blank diskette, and press any key. This diskette is the “target” diskette,
the diskette on which the information is being copied.
The in-use light comes on while the system is copying the information
onto the target diskette. If the blank diskette is not formatted, the
message
Formatting While Copying
appears on the screen.
NOTE: Depending on the amount of memory on your PC, the system may
prompt you to swap diskettes during diskcopy.
When the copying process is finished, you see:
Copying complete
Copy another diskette (Y/N)?
Remove the duplicate diskette, write “SYSTEM 25 CMS SYSTEM
WORKING COPY” on a label using a felt tip pen, apply the label to the
diskette, and put the diskette in its paper sleeve. Return the original
diskette to its paper sleeve.
Type
y. The following message appears:
Insert SOURCE diskette in drive A:
Strike any key when ready...
Insert the original CMS diskette labeled “SYSTEM 25 CMS REPORT AND
ADMIN” into drive A. This is the source diskette.
Repeat Steps 4 and 5, using the second blank diskette as the “target”
diskette.
Duplicating the CMS Diskettes 3-3