User`s guide

RECORDING MESSAGES
The following steps describe how to record a message on your DACON voice
announcement unit. Figure 2-3 shows you the front of the unit.
FIGURE 2-3 The DACON-DA-5SL Voice Announcement Unit.
NOTE: If you are recording only one message, the message can be up
to 64 seconds in length. If you are recording two messages, one
message on Channel 1 and one on Channel 2, you must divide the 64
seconds of message time between the two messages.
Prepare a clear, informative message before you begin to record. Once you
have plugged in the voice announcement unit and turned it on, use the
following instructions to record a message on Channel 1.
1
Turn your DACON unit so that the front of the unit is facing you.
2
Insert the handset modular plug into the front panel jack.
3
To record on Channel 1, the red light on the Channel button must be off.
If the light is on, press the Channel button once so that the light goes off.
4
Press the Record button and hold it down while you press the Play
button.
(The Channel button light flashes during the first 16 seconds of your
recording. The Record button light flashes during the second 16 seconds.
The Play button light flashes during the third 16 seconds. The On-Line
button light flashes during the fourth 16 seconds.)
5 Speak into the handset to record your message.
6
When you are finished recording your message, press the On-Line button.
To record a message on Channel 2, follow this procedure:
1
The red light on the Channel button must be on. If the light is off, press
the Channel button once.
(The red light on the button goes on.)
2
Repeat steps 4 through 6 above to record the message.
CMS Components 2-17