User`s guide

Voice Announcement Unit Problems
After correcting a voice announcement unit problem, bring the unit back into
service as follows:
1 From the System Status screen, press [F2] (labeled “Select Anncs” ).
2 Press [F1] (labeled “Select Annc”).
3 Enter the number of the announcement unit; then press [F8] (labeled
“Enter Data”).
4 Press [F3] (labeled “Change Condtn” ) once to change the announcement
unit condition from
BROKN to REMVD.
5 Press [F3] again to change the condition to AVAIL .
CMS immediately attempts to test the unit.
9-22 Voice Announcement Unit Problems