User`s guide

Prompt: SAVE CONFIGURATION: in Config #: ___
Action: 1 Press [F8] (labeled “Enter Data”) to save the edited
configuration under the same configuration name and number
as the original (in other words, to replace the original with the
edited copy).
or
Enter another configuration number and press [F8] (labeled
“Enter Data”) to save the edited configuration under a
different configuration number.
A second prompt appears:
SAVE CONFIGURATION: Replace Contents of Config #X - NAME? (Y/N):___
The number of the configuration you want to replace and its
name appear in this prompt.
2 Type y to confirm your request or n to cancel it.
3 Press [F8] (labeled “Enter Data”).
[F3] Rename Config (Rename Configuration)
Press this function key to name or rename a configuration. Configuration
names can contain up to 10 uppercase letters, numbers, or special characters.
Spaces are not allowed, so you may want to use hyphens or underlines
instead.
Prompt:
RENAME CONFIGURATION: Config # (1-6):___ New Name:
Action: 1 Enter the configuration number (1 through 6).
2 Enter the new name (up to 10 uppercase letters, numbers, or
special characters).
3 Press [F8] (labeled “Enter Data”).
NOTE: If you rename an inactive configuration as “UNUSED", you
will delete its contents. The current configuration cannot be renamed
“UNUSED” since an unused configuration cannot be activated.
Also, if you attempt to rename the startup configuration "UNUSED",
an error message appears on the screen.
[F4] Choose Startup (Choose Startup Configuration)
Press this function key to select a shift configuration to be invoked
automatically during call management startup. Don’t select a startup
configuration, however, if you want to choose a startup configuration each
time you begin call management.
5-46 Dynamic Reconfiguration