Instruction manual

Programming the MERLIN LEGEND System for CMS
Setting Up the Operator Positions
CMS requires three operator positions—
two for the CMS PC (ports CU1 and
CU2) and one for the CMS supervisor. All CMS lines or trunks, external alerts,
and loop-backs are assigned to these positions. The following sections give
instructions for setting up these three positions.
Identify CMS Operator Positions
Identify three analog DLC operator positions. The two CMS PC positions
(CU1 and CU2) must be on the same analog module. Note that, none of
these positions should be extension 10, the MERLIN LEGEND primary opera-
tor position. To locate the operator positions, refer to Form 5a, Direct Line
Console (DLC)—Analog.
Step
MLX-20L
PC
1.
Display Direct Line
Operator
[F3]
Operators entry screen
Positions
[F1]
Direct Line
[F1]
2.
Identify and assign DLC
Dial extension,
Type extension,
operator positions
slot and port, or
slot and port, or
logical ID logical ID
Enter
[F10]
Repeat for each position
3.
Save all entries
StoreAll
[F3]
The system will restart
Setting Up the Operator Positions 1-15