Instruction manual

Programming the MERLIN LEGEND System for CMS
Program T1 Lines
If the MERLIN LEGEND system has 100D (DS1) modules with T1 lines to be
used by CMS, you must specify the emulation for each T1 channel. Channels
used for CMS must be programmed for ground-start emulation. To identify
DS1/T1 lines, refer to the “Jack Type” column on Form 2c, System
Numbering—Trunk Jacks.
NOTE:
Other channels in a T1 line not assigned to CMS may have other emulations.
Step
MLX-20L
PC
1. Identify the slot number
LinesTrunks [F4]
with the 100D module
GS/LS/DSl
[F1]
and save entry
Dial slot number
Type slot number
Enter [F10]
2.
Specify T1 for the line
Type
[F1]
type and save entry
T1
[F1]
Enter
[F10]
3.
Specify ground-start
emulation
— To select all channels
All Ground
[F6]
Enter
[F10]
Go to step 5
Go to step 5
— To select some chan-
GroundStart
[F1]
nels
Enter
[F10]
4.
Identify channel(s) and
Dial channel
Type channel
assign type
number
number
Enter
[F10]
Setting Up Lines, Trunks, and Pools for CMS 1-13