Instruction manual

Programming the MERLIN LEGEND System for CMS

— For logical IDs 41-60

Lines 41-60

[F3]

— For logical IDs 61-80

Lines 61-80

[F4]

Remove each CMS

Press line but- Press function

trunk, external alert, and

ton for each

key for each

loop-back from the pool trunk until red

trunk until letter

LED is off

“R” is erased

Exit to System Program-

Exit

[F5]

ming

Exit

[F5]

Remove CMS Lines, External

Alerts, and Loop-Backs from Telephones

A MERLIN LEGEND system operating in key mode automatically assigns up

to 32 lines on telephone line buttons, depending on the type of telephone. In

hybrid/PBX mode, the system automatically assigns trunks to operator tele-

phones. If any of these lines or trunks are CMS lines or are used for CMS

external alerts or loop-backs, remove them from all telephones in a key sys-

tem and from all operator telephones in a hybrid/PBX system. (Make sure the

CMS lines are first removed from the default pools. See the previous pro-

cedure.)

In steps 1-5 below, you first remove CMS lines, external alerts, and loop-

backs from one agent phone (in a key system) or from one operator phone (in

a hybrid/PBX system). In steps 6-9, you copy the assignments from that

phone to other agent or operator phones. You cannot copy line assignments

between operator and non-operator phones in a hybrid/PBX system.

To identify CMS lines, external alerts, and loop-backs, refer to Form 2c, Sys-

tem Numbering—Trunk Jacks.

NOTE:

For any CMS lines or trunks connected to MERLIN LEGEND jacks above logi-

cal ID 32, you may skip this procedure. No lines or trunks above logical ID

32 default to telephones.

Setting Up Lines, Trunks, and Pools for CMS

1-11