Instruction manual

Troubleshooting
The message was lost due 1. Make sure the battery is turned on.
to a power outage.
2. Record the message again.
Message 2 is selected, Select message 1, or record message 2.
but not recorded.
Lines are not identically
Program lines for CU1 and CU2 identically.
programmed for CU1 and
CU2.
WARNING--Message Unit Problem. Check Message Length.
Status Indicator: MSG
Possible Cause
Corrective Action
The delay message is at Listen to and time the delay message for both
least five seconds longer
day and night. Then do one of the following:
than the number of
■ Record a new delay message.
seconds entered for
■ Enter the correct number of seconds for
“Delay Message Length”
“Delay Message Length” on the Set
on the Set Options screen.
Options screen.
The lines assigned to CU1
Ask the MERLIN LEGEND manager to check
and CU2 do not match the line assignments for the two jacks
exactly.
assigned to CU1 and CU2. Follow instructions
for the “Line Status Test” in Chapter 7.
■ If the assignments do not match, repro-
gram the lines so that they do.
■ If the assignments match, check the
connections to the control unit to be
sure the lines are connected properly.
Warning Messages 9-9