Instruction manual

Building a Shift Configuration
5. Press [F8] three times to exit to DOS (from the CMS Main Menu).
The c> prompt should appear.
NOTE:
If you exit the Administration Menu without saving the shift configuration
changes, a series of prompts ask if you want to save the entries you
made in the configuration.
6. Insert the diskette labeled “CMS Backup” into disk drive A and enter
the following commands from the c\ > prompt:
cd \cms\cmsmgmt
copy shift*.cms a:\cms\cmsmgmt
copy systbls*.cms a:\cms\cmsmgmt
cd \cms
7. Remove the backup diskette and write the current date on the label.
Store the diskette in the back cover pocket of the CMS Supervisor’s
Guide.
Choosing a
Start-Up Configuration
When you start Call Management, you should also select a start-up
configuration. CMS uses this configuration for handling calls. To start Call
Management and select a start-up configuration, complete the following
steps:
1. If the CMS PC is off, turn it on and wait until the CMS Main Menu
appears. If the CMS PC is on, and the c\ > prompt is displayed, type
cms [ [ ↵ ↵ ]] . If any other CMS screen is displayed, press [F8] until the
CMS Main Menu appears.
2. On the CMS Main Menu, press [F1] (Start Call Mgt) to begin call
management.
Choosing a Start-Up Configuration 6-15