Instruction manual

Building a Shift Configuration
3. Enter the configuration’s number and the new configuration name.
4. Press [F8] (Enter Data) to save the name.
The prompt disappears, the screen’s function keys replace the editing function
keys, and the new name for the shift configuration appears on the screen.
NOTE:
You cannot rename a configuration labeled UNUSED. You must select the
configuration first, then either build it or go back to the Configuration List
(Config List) to rename it.
Saving a Split Configuration
After building a new or changing an existing split configuration, you should
save the changes. Saving changes is a two-stage operation: first you save
them to the CMS PC and then you save them on the CMS Backup diskette.
When you save a shift configuration, also save the system tables that contain
information used by the configuration. Store the floppy disk in the pocket of
the back cover of the CMS Supervisor’s Guide.
To save the split configuration:
1. On the Stored Shift Configuration screen, press
[F2] (Save Config).
The editing function keys replace the screen’s function keys, and the following
prompt appears on the prompt line:
SAVE CONFIGURATION :
Into Config #:_
2. Enter the configuration’s number.
3. Press [F8] (Enter Data) to save the configuration.
Another prompt asks you to confirm the save.
4. Answer Y to save the configuration.
The prompt disappears, the screen’s function keys replace the editing function
keys, and the new name for the shift configuration appears on the screen.
6-14 Naming and Saving the Shift Configuration