User manual
Table Of Contents
- Getting Started
- Settings
- Apps
- Technical Data
- Health/Safety/Warranty Guide
- Important health information and safety precautions
- Safety precautions for proper grounding installation
- Safety precautions for power supply unit
- Electrical safety
- Follow these other specific precautions:
- Prevention of hearing loss
- Safety precautions for direct sunlight
- Environmental restrictions
- Aircraft safety
- Road safety
- Safety precautions for rf exposure
- Explosive atmospheres
- Interference with medical equipment functions
- Non-ionizing radiation
- Battery information and precautions
- Danger!
- Warning!
- Caution!
- FCC notice and cautions
- HAC
- Safety information
- FDA Consumer Update
- 1. What is the FDA's role concerning the safety of wireless phones?
- 2. Do wireless phones pose a health hazard?
- 3. What are the results of the research done already?
- 4. What kinds of phones are the subjects of this update?
- 5. What is the FDA doing to find out more about the possible health effects of wireless phone RF?
- 6. What research is needed to decide whether RF exposure from wireless phones poses a health risk?
- 7. What has the FDA done to measure the Radio Frequency energy coming from wireless phones?
- 8. How can I find out how much Radio Frequency energy exposure I can get by using my wireless phone?
- 9. What about children using wireless phones?
- 10. What steps can I take to reduce my exposure to Radio Frequency energy from my wireless phone?
- 11. What about wireless phone interference with medical equipment?
- 12. Where can I find additional information?
- Nine Driver Safety Tips
- Consumer Information on SAR (Specific Absorption Rate)
- Important health information and safety precautions
69
particular wireless phone. “Normal usage” in this context is defined as a signal quality
that’s acceptable for normal operation. The M mark is intended to be synonymous with
the U mark. The T mark is intended to be synonymous with the UT mark. The M and T
marks are recommended by the Alliance for Telecommunications Industries Solutions
(ATIS). The U and UT marks are referenced in Section 20.19 of the FCC Rules. The HAC
rating and measurement procedure are described in the American National Standards
Institute (ANSI) C63.19 standard. When you're talking on a cell phone, it's recommended
that you turn the BT (Bluetooth) mode off for HAC.
For information about hearing aids and digital wireless phones:
Wireless Phones and Hearing Aid Accessibility
http://www.accesswireless.org/Home.aspx
FCC Hearing Aid Compatibility and Volume Control
http://www.fcc.gov/cgb/consumerfacts/hac_wireless.htm