User`s guide

AUDIX Administration and Data Acquisition Package 585-302-502 Issue 17
May 2002
Using the ADAP Command Line Language
11-11Command Line Commands
11
When using the -v option or pressing v in communicating the voice mail
system, the following information appears in the following sequence
:
You do this in a manner similar to the above. Prior to executing retrieval and
modify commands, set the AUDIX_RELEASE environment variable to the
release value you want by entering one of the commands listed below:
set AUDIX_RELEASE=I-r2.0
set AUDIX_RELEASE=I-r3.2
set AUDIX_RELEASE=I-r3.3
set AUDIX RELEASE=I-r4.0
To clear this environment variable, enter the following command:
set AUDIX_RELEASE=
without a release value. This restores I-r5.0 as the default release value.
-v Verbose flag. This option displays information about the
data transfer from the voice mail system to ADAP when
the data transfer is complete.
The following options are available for both retrieval and modification
command
s
q Press during transmission to quit the transfer gracefully.
This may take some time.
v Press during transmission to view the current
transmission statistics on the screen.
NOTE:
For screens with very little data, and, therefore, a very rapid transfer rate, the
transmission may complete before you are able to press q or v.
DEFINITY and I
NTUITY AUDIX
Systems R1 AUDIX Systems
Elapsed time of the full data
transmission
Number of packets sent
Number of files/forms transmitted Number of packets received
Total characters in the files/forms Number of packets retransmitted due
to packet/protocol errors
Total number of bytes received No. of characters of screen data
received