User guide

Initial System Administration
3-26 Issue 1 September 1995
Task 14L: Check Alarm Status
This task is required for all installation scenarios.
1. With the cursor on the DEFINITY AUDIX command line, type display
alarms and press .
The system displays the Alarm Report screen.
2. Check the ALARM TYPES fields for any active alarms — make sure that a
“y” (the default) appears in each of the alarm type fields and press
(F3) to display the active alarms.
3. If there are no active alarms (the screen will be blank), skip to Step 4.
Otherwise, resolve all active alarms. See
DEFINITY AUDIX
System—Maintenance
book, 585-300-110 for the procedures for
identifying and resolving the alarms.
4. Proceed to Task 14M: Check Hardware Status.
Task 14M: Check Hardware Status
This task is required for all installation scenarios.
1. With the cursor on the DEFINITY AUDIX command line, type
list configuration and press .
RETURN
ENTER
RETURN