User guide

Windowing on the 715 Terminal
Issue 1 September 1995
3-3
Windowing on the 715 Terminal
If you are using the 715 BCT terminal, you should be aware of its windowing
capabilities. You can use the 715 terminal to log on to both the switch and the
DEFINITY AUDIX system to perform administration tasks and easily toggle back
and forth between the two sessions.
The windowing functions are controlled by the four function keys, F1, F2, F3, and
F8 as described in Table 3-1, Function Keys Used for Windowing on the 715
BCT.
Task 11: Perform Initial Switch
Administration
This task is required for all installation scenarios.
Before beginning the initial administration tasks on the DEFINITY AUDIX system,
you must perform administration tasks on the switch to prepare the switch for the
DEFINITY AUDIX system.
Because this task may differ depending on the switch in which you are installing
the DEFINITY AUDIX System, the details are described in
Switch Administration
for the DEFINITY AUDIX System
book, 585-300-509.
Table 3-1. Function Keys Used for Windowing on the 715 BCT
Key Operation
Ctrl+F3 Enables the windowing function keys and displays their labels
F1 Turns off the windowing function keys
F2 Toggles between the DEFINITY AUDIX system window and the
switch window
F3 Toggles between split-screen and full-screen modes
Ctrl+F8 When in the DEFINITY AUDIX system window, this key enables
the DEFINITY AUDIX function keys and displays their labels.
Ctrl+F3 enables the windowing keys again and displays their
labels.