User guide

Upgrades to R3.2
7-22 Issue 1 September 1995
31. [5 min]
Run
SAVE WEEKLY. When the administration alarm, A, appears on the status
line, run
DISPLAY ADMINISTRATION-LOG. If the SAVE WEEKLY operation was
successfully completed,
save manual_weekly passed will be displayed.
32. Enable alarms by entering
ENABLE ALARM-ORIGINATION.
33. If you do not have to install Intuity Message Manager, enter logoff to log
off the system. If Intuity Message Manager is going to be installed,
continue with the
After the Upgrade section of this document.
This completes the procedure for the R3.2 software upgrade.
After the Upgrade
If Intuity Message Manager is part of the R3.2 upgrade, the language sets must
be added. Continue through the following sections.
Installing, Administering, and Testing Intuity
Message Manager
Perform the following steps to install, administer, and test Intuity Message
Manager. The LAN administrator should be present.
NOTE:
A 10BaseT twisted pair LAN cable with a male RJ-45 connector must be
present at the wall field before Intuity Message Manager can be in tested.
This is the customer’s responsibility. AT&T will install the Intuity Message
Manager to the demarcation point, but cannot test until this twisted pair is
installed.
The connector can be no farther than 25 feet from the back of the switch where
DEFINITY AUDIX resides. Confirm with the LAN administrator prior to the
software upgrade that a connection is available.
1. Remove the top of the104A connecting block.
Inside, eight wires must be hard-connected across the two mounting
blocks , as shown in Figure 7-3,
104A Mounting Block . Four protector
caps snap over the top of the mounting blocks