User guide

Task 26: Add the Initial Subscribers
Issue 1 September 1995
5-3
The system responds with the Subscriber screen.
2. With the cursor at the Name field, type the name of the first subscriber
listed on Worksheet C-8.
3. Move the cursor to the Extension field and type the extension of the first
subscriber.
4. Press the (F3) function key to add the subscriber.
5. Repeat steps 1 through 4 for each subscriber listed on the
Adding
Subscribers
worksheet.
6. If running in a DCS environment, repeat steps 1 through 4 for each initial
remote subscriber.
NOTE:
Make sure that each DCS remote subscriber is assigned the correct
switch number. The switch number for DCS remote subscribers is
not the same as the host switch number. The Switch Number field on
the Subscriber screen must match the switch number for the
subscriber’s switch on the SWitch Link Dciu-Sci screen (see Task
14E: Set Switch-Link Parameters). If digital networking is being
implemented, then turn to:
Definity AUDIX system-Digital Networking ,
585-300-534. This book describes how to add remote subscribers for
digital networking.
7. Proceed to Task 27: Switch Names Audit (for DS integration Only).
ENTER