AT&T User's Manual for Cordless Digital Answering System Teleniione 7650 Fold open this manual for information about this telephone's installation and operation. Please read Part 1 — Important Product Information, included rn -v'-.i/r .> •,'l-nr'!' Parti © 1996 Lucent Technologies Inc. All rights reserved. Printed in Mexico. Issue 2 AT&T and the globe symbol are trademarks of AT&T Corp. licensed to Lucent Technologies Inc.
I H S T B l l A T I O N Modular Wall Jack Standard AC Outlet AC Adapter TABLE INSTALLATION Choose a spot near an electrical outlet and a telephone jack. ••This phone requires a modular telephone jack and a standard electrical outlet (1 lOV AC). • The outlet should not be con trolled by a wall switch; if the switch is turned oif, the phone will not operate. Install the handset battery. ••Remove the battery case cover on the handset by pressing on the indentations and sliding the cover downward.
I N S T A L L A T I O N Base Antenna (extended) PHONE light goes on while handset is on a call. CHARGING light goes on while handset battery is charging. LO ВАТТ BASE goes on when base battery power is low. Use CLOCK with CHANGE to set or change time/day. Directory Card Use ANNC with CHANGE to record outgoing announcement. Use CHANGE wUh CLOCK and ANNC. Message Alert Ringer Switch Ring Select Page/Find WALL M0UNTIN8 INSTALLATION 1 2 3 4 Follow Steps 1-5 in TABLE INSTALLATION.
B A T T E R I E S CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and fol 1 low these instructions carefully. • For the handset, use only the battery provided with this phone, or AT&T Replacement 2 Battery 4051. • Do not dispose of the battery in a 3 fire. The cell might explode. • Do not open, puncture or mutilate the battery. Released electrolyte is corrosive and might cause damage to the eyes or skin. It might be toxic 4 if swallowed.
T E L E P H O N E O P E R A T I O N Temporary Tone Making a Call 1 2 Press :PHONE', and wait for the PHONE light to go on. Vv lien you hear a dial toue. uiai liic number. " NOTE: You might experience a slight delay before you hear a dial tone, as the AutoSelect® feature searches fora clear channel. Answering a Call If the handset is in the base, lift the handset. The PHONE light goes on, and the call is connected. If the handset is away from the base, press ¡phone .
M E M O R Y This cordless phone can store nine telephone numbers that you can dial just by pressing MEMORY: and one of the number buttons. NOTE: The numbers stored in memory might be lost when you change the handset batteries or if the batteries run down completely; if this happens, you'll need to store the numbers again. Storing a Number In Memory ANS SYSTEM light goes on while Answering System is accessed from handset. Access Answering System Operation from handset. Change channels.
O P E R A T I N G This cordless telephone operates at the maximum power allowed by the Federal Communications Commission (FCC). Even so, the handset and base can communicate over only a certain distance — which can vary with the locations of the base and handset, the weather, and the construction of your home or office. For best performance, keep the base and handset antennas fuUy extended.
RNSWERIH6 SYSTEM OPERATION. A n s w e r i n g S y s t e m Mailboxes O p e r a t i o n f r o m Automatic Answering Operation t h e B a s e Save Your Messages The system is ready to answer calls when it is turned on and the memory is not full. After you hsten to your messages, the system automatically saves them, and is ready to answer new calls. Callers can choose in which mailbox they wish to leave a message by press ing 'Q] or -2] on a touch tone phone after the system answers.
ANSWERING SYSTEM OPERATION. A n s w e r i n g S y s t e m O p e r a t i o n f r o m t h e B a s e Stop message playback or recording Fonvard/Skip Messages Record a memo (with MAILBOX) ON/OFF Delete Messages Mailbox 2 Message Alert Mailbox 1 Repeat/Review Messages Microphone Message Volume Control Ring Select Priority Calling Callers to whom you've given the Priority Calling Code will be able to signal you that they are calling. Callers must use a touch tone phone.
.ANSWERING SYSTEM OPERATION.. Answering System Operation from Cordless Handset or Remote Touch Tone Phone You can operate the answering system from the cordless handset, or from any touch tone phone away from your home or office. The labels above the number K..4 ,....1...M 1 1 .) V^n LtiL. ! • Play All Messages Р|ЧП ЧЧ'М •'1 llUiiUjsCl. w i l l remind you of the correct buttons to press for each operation. Record a Memo Press and release f f ) .
IN CASE OF DIFFICULTY If you have difficulty operating this phone, try the suggestions below. If you still have trouble, call the National Service Center at 1 800 222-3111. To turn Answering System Offfrom a remote location 1 Dial your telephone number. 2 When the answering system responds, enter your 2-digit Remote Access Code. The system announces whether or not you have any messages, then beeps twice and is ready to accept a command. 3 Press ¡#i, % to turn the system Off.
IN CASE OF DIFFICULTY If you hear noise in the handset and the buttons don’t work: • The base unit and handset might not be set to the same security code. Place the handset in the base for at least 15 seconds to reset the security code. If you hear other calls while using the phone: » Press iCHANNEL. to Change to another channel. • Disconnect the base from the telephone jack and plug in a regular telephone. If you still hear other calls, the problem is probably in your wiring or local service.
PHONE OFF ANS SYSTEM REDIAL MEMORY CHANNEL AUUSC N£WUSC obc^ 2 1 r ^ghi^ 4 AhN~ /*/ 5 ja>t ''pq^ 1 tone * 8 Oite- = ^ oper 0 aiMktsc del 3 moo 6 MTir/ 9 CHMC€ ^ 'N #
.1^ <1 > I * tíjmcm
