User`s guide

Installing Your Voice Terminal

Refer to the sections, ‘‘Connecting a Personal Computer and an Analog

Adjunct to the 8411 Voice Terminal,’’ later in this manual, for information

about connecting a personal computer to an 8411 voice terminal for use

with the AT&T PassageWay Solution software or connecting the 8411

voice terminal with analog equipment such as an answering machine, fax

machine, or modem.

9. Lift the handset and listen for dial tone. If there is no dial tone, check all

wire connections to make sure they are secure. Also, perform a self-test

to see if the terminal is receiving power from the switch. (See ‘‘Using the

Test Feature and the Diagnostics Feature’’ later in this manual.)

Adjusting the 8410D Voice Terminal

Desktop Stand

To ensure better display visibility on the 8410D set, the accompanying desktop

stand can be installed in a high or low position. (When each of these voice

terminals is shipped from the factory, the stand is in the low position.) Figure 5

shows you the set of tabs to use for each position. Check which position allows

the user the best viewing angle of the display, and then use the following short

procedure for installing the desktop stand in the selected position.

To reinstall the desktop stand on the 8410D voice terminal for the low or the

high position (See Figure 5.)

1. Place the lower desktop stand tab in the appropriate voice terminal tab

slot.

2. Slowly lower the desktop stand until the top tab fits into the appropriate

tab slot at the top of the voice terminal. You may need to press inward on

the top of the desktop stand (see Figure 5) in order for the tab to fit into

the slot.

NOTE:

As noted before, if you choose to install the desktop stand in the high

position, you may need to pass the cords through the long, rectangular

opening that surrounds the jacks and then plug the cords into the jacks

BEFORE you place the stand on the back of the voice terminal.