USER’S MANUAL Part 2 DRAFT 7/10/01 900 MHz Cordless Telephone 6200 Please also read Part 1 — Important Product Information AT&T and the globe symbol are registered trademarks of AT&T Corp. licensed to Advanced American Telephones. Net2Phone is a registered trademark of Net2Phone, Inc. © 2001 Advanced American Telephones. All rights reserved. Printed in China.
INSTALLATION Before You Install 1 2 Choose a location for the base near an electrical outlet and a telephone jack. This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch. a) Remove battery compartment cover by pressing on the indentation and sliding downward. Install the handset battery following Figure A below. Attach the belt clip to the cordless handset as in Figure B below (optional).
INSTALLATION Wall Installation 1 2 3 4 5 Position the wall mount adapter on the base. Connect the telephone line cord. Connect the power cord. Mount the base on the wall. Follow Steps 3 and 4 in Table/Desk Installation. a) Align tabs on wall mount adapter with holes on bottom of base. Snap wall mount adapter firmly into place. Align holes on base with mounting studs on wall jack. Mounting Studs b) Place power cord as shown, so it hangs straight down between base and wall.
TELEPHONE OPERATION On steadily when handset is in base Page/Handset Locator Handset Volume Adjust volume of what you hear through the handset. Press once to page the handset for up to one minute — OR — Press twice to cancel. Flash/Call Waiting Access special telephone company subscriber services. Make or Answer a Call Net2Phone Access your Net2Phone account for internet calling. Lift handset from base — OR — Press P and wait for light to go on steadily.
TELEPHONE OPERATION Making a Net2Phone Call • Handset Ringer Style Press P, on the cordless handset to access your Net2Phone account. Follow the voice prompts to complete your call. You can select from four different handset ringer styles. 1 Make sure the handset is off. 2 Press g, #. 3 Press 1, 2, 3 or 4 to select your ringer style. You will hear a sample of the ringer style. 4 Press g. Changing your Net2Phone Access Number This phone is pre-programmed to dial 1 866 333-8506 when you press .
TELEPHONE MEMORY This cordless phone can store nine telephone numbers, each up to 16 digits long. Store Memory Numbers 1 Make sure the handset is off. 2 Press g. The PHONE light blinks. 3 Dial the telephone number (up to 16 digits) — OR — Press R to store the last number dialed. 4 Press g. 5 Press the number button (1–9) where you want to store the telephone number. Change/Replace a Stored Memory Number Store a new number in its place.
BATTERIES Charging the Handset Battery Pack Replacing the Handset Battery Pack This battery should remain charged up to six days with the ringer turned on and up to 12 days with the ringer off. A fully charged battery provides an average talk time of about six hours. 1 2 3 The battery pack needs charging when: • A new battery is installed in the handset. • The phone beeps twice when you press P. • The phone light flashes slowly. Place the handset in the base so the CHARGING light turns on.
IN CASE OF DIFFICULTY If you have difficulty operating this phone, try the suggestions below. For Customer Service, visit our website at www.telephones.att.com or call 1 800 222–3111. Please retain your receipt as your proof of purchase. If you hear noise or interference when using the phone: • • • If the phone doesn’t work at all, check these items first: • • • • • • Make sure the AC adapter is plugged into an outlet not controlled by a wall switch.
