User Manual

38
Appendix
If you have diculty with your telephone, please try the following suggestions.
For customer service, or to purchase accessories or replacement parts, visit
our website at www.telephones.att.com or call 1 [phone]. In
Canada, dial 1 [phone].
My telephone does not work at all.
Unplug the batteries and telephone line cord. Wait for approximately 15
seconds, then plug them in again. Allow up to one minute for the telephone
to synchronize.
There is no dial tone.
Try the suggestion mentioned above.
The telephone line cord may be defective. Try installing a new telephone
line cord.
Make sure the coiled handset cord is securely installed between the handset
and the telephone base.
Disconnect the telephone base from the telephone jack and connect a
dierent telephone. If there is no dial tone on that telephone either, the
problem is in your wiring or telephone service. Contact your telephone
service provider (charges may apply).
I cannot dial out.
Try all suggestions mentioned above.
Make sure there is a dial tone before dialing. It is normal if the telephone
takes a second or two before producing a dial tone. Wait an extra second
before dialing.
Check that all the telephones connected to the same telephone line are
hung up.
Make sure to set the DIAL MODE to the correct setting (touch-tone dialing or
pulse dialing) for the service in your area (see Dial mode on page 12).
If any of your other telephones are having the same problem, the problem is
in the wiring or telephone service. Contact your telephone service provider
(charges may apply).
If you are using the speakerphone, eliminate any background noise. Noise
from a television, radio, or other appliances might cause the telephone to
not dial out properly. If you cannot eliminate the background noise, rst try
muting the telephone before dialing, or dialing from another room in your
home with less background noise.
•
•
•
•
•
•
•
•
•
•
•
Troubleshooting