Instruction manual

VFO settings, including MENU group contents such as sub-

audible tone frequency and offset can be programmed into a

memory channel.

qSet the desired frequency in the desired band

(left or right).

➥ Push the desired band’s [V/MHz•SCAN] to select VFO

mode.

➥ Set the frequency using the same band’s [DIAL].

➥ Set other data

(e.g. tone frequency, duplex information, etc.)

if required.

wPush and hold the same band’s [M/CALL•MW] for 1 sec.

•2 beeps sound

•“X” indicator and the memory channel number blink.

eRotate the [DIAL] to select the memory channel to be pro-

grammed.

• Memory channels not yet programmed are blank.

rPush and hold [S.MW](M/CALL•MW) (Left band’s) for 1 sec.

to program.

•3 beeps sound

• Memory channel number automatically increases when contin-

uing to push [M/CALL•MW] after programming.

✔FOR YOUR ONVENIENCE

Memory programming can be performed in various ways e.g.

memory channel to the same (or different) memory channel,

memory channel to the call channel, etc.

■ Programming a memory channel

[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the controller.

Push Rotate for setting frequency, etc. Push and hold for 1 sec.

Rotate Push and hold for 1 sec. and continue to push

➠

Beep

“

V/MHz

SCAN

M/CALL

S.MW

Beep

“

Beep

“

MEMORY MODE OPERATION