Instruction manual

112
13
MENU SCREEN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
DD
GPS-A symbol
Selects the desired GPS-A symbol.
Available symbols: Ambulance, Bus, Fire Truck, Bicycle,
Yacht, Helicopter, Small Aircraft, Ship
(Power Boat), Car
(default), Motorcycle,
Balloon, Jeep, Recreational Vehicle,
Truck, Van, Other
If “Other” is selected, set the desired symbol code as follows;
qPush [MAIN•BAND] to enter programming condition.
wRotate [DIAL] to select the 1st character from “\” and “/.”
ePush [>](M/CALL•MW)
(Left band’s) to select the 2nd digit.
rRotate [DIAL] to select the 2nd digit character.
tPush [MAIN•BAND] to program the symbol code.
When “Other” is selected, check the symbol codes of
APRS,
®
and set it correctly.
DD
Comment
Program up to a 43-character* comment. The programmed
comment is transmitted with the GPS position data.
*36-character comment can only be programmed when
“COURSE/SPEED” is selected in data extension.
qPush [MAIN•BAND] twice to enter programming condition.
wRotate [DIAL] to select the desired character.
• Push [Aa](TONE•DTMF) to select the character group from cap-
ital letters or lower case letters.
• Push [1/](M/CALL•MW) (Right band’s) to select the character
group from numbers or symbols.
• Push [>](M/CALL•MW) (Left band’s) or [<](V/MHz•SCAN) (Left
band’s) to move the cursor right or left, respectively.
• Push [CLR](DUP/MONI) to clear the selected character.
• Push and hold [CLR](DUP/MONI) for 1 sec. to clear all charac-
ters after the selected character.
eRepeat steps w until the desired comment is programmed.
rPush [MAIN•BAND] to set the programmed comment.
tPush [BACK](V/MHz•SCAN)
(Right band’s) to return to the
GPS-A set mode screen.