Instruction manual

111
13
MENU SCREEN OPERATION
■ GPS-A SET MODE items
DD
Unproto address
Sets up to 56-character unproto address.
qPush [MAIN•BAND] to enter programming condition.
wRotate [DIAL] to select the desired character.
• Push [Aa](TONE•DTMF) to select the character group from cap-
ital letters or lower case letters.
• Push [1/](M/CALL•MW) (Right band’s) to select the character
group from numbers or symbols.
• Push [>](M/CALL•MW) (Left band’s) or [<](V/MHz•SCAN) (Left
band’s) to move the cursor right or left, respectively.
• Push [CLR](DUP/MONI) to clear the selected character.
• Push and hold [CLR](DUP/MONI) for 1 sec. to clear all charac-
ters after the selected character.
eRepeat steps w until the desired address is programmed.
rPush [MAIN•BAND] to set the programmed address.
tPush [BACK](V/MHz•SCAN)
(Right band’s) to return to the
GPS-A set mode screen.
DD
Data extension
Sets the data extension capability from “COURSE/SPEED”
and OFF
(default).
The transceiver’s course and speed information is addition-
ally transmitted with position data when “COURSE/SPEED”
is selected.
NOTE: When “COURSE/SPEED” is selected, number of
character for “COMMENT” is limited to 36-character.
DD
Time stamp
Selects transmitting time stamp type from DHM, HMS and
OFF. This function can be transmitted UTC
(Universal Time Co-
ordinated) time only.
• OFF : No time stamp is transmitted.
(default)
• DHM : Time stamp in the format of Day, Hour and
Minute is transmitted.
• HMS : Time stamp in the format of Hour, Minute and
Second is transmitted.