User`s manual

22
Answering System Feature Setup
You can set up one feature at a time, or you can set up a feature and then
move on to set up another feature.
1 Make sure the answering system is on.
2 Press and release U until you hear the system announce the
feature you want to set. Refer to the “Feature Summary” below for a
description of the features and your choices.
3 Press c to hear the feature’s settings.
4 Press t to confirm your selection.
Feature Summary
Default settings indicated by
*
.
System announces: Description/directions:
“Change remote access code” Set the remote access code you will use
50
*
to access features and functions of the
answering system from a touch tone phone.
The code can be changed to any two-digit
number from 40-99.
“Change message alert” When Message Alert is turned on, the base
Off
*
beeps once every 10 seconds when new
On messages have been received.
“Change announce only” When you turn Announce Only on, callers
Off
*
hear your announcement, but cannot
On leave a message.
“Change call screening” When call screening is turned on, you
On
*
can monitor the incoming message.
Off
“Change number of rings” Choose how many times the phone will
2ring before the system answers a call.
4
*
With Toll Saver active, the system answers
6 after two rings when you have new
Toll Saver messages and after four rings when you
have no new messages.
NOTE: Exit Feature Setup at any time by pressing a MBOX/STOP button.
NOTE: In the event of a power failure, your feature settings and volume settings
will be saved automatically.
ANSWERING SYSTEM OPERATION
AT THE BASE
91-5824-70-00_ATT1480_R0 9/15/03 2:47 PM Page 22