User`s manual

10
TELEPHONE OPERATION
AT THE BASE
Speaker Volume
While on a call, use to
adjust the volume of
what you hear.
Mute
Press M to
prevent your caller
from hearing you (you
can hear your caller).
Press again to deactivate.
MUTE light is on when
Mute is activated.
Base Ringer Volume Switch
Use to adjust how loudly the
base rings.
Display Dial
Press to dial the number
currently displayed on screen.
Make, Answer,
or End a Call
Press K. When
calling, use the base
keypad to dial or enter
a memory location.
SPEAKER light is on
when call is connected.
—OR—
Hold
Press H to put a call
on hold. The IN USE
light flashes. To return to
the call, press K.
NOTE: When Hold is
active, pressing P on
handset will also return
you to the call.
Flash
Access subscriber services while on a call.
Redial
Press to call the last
number dialed at the
base (up to 32 digits).
Page/Intercom
1 Press and release to signal someone at the handset. A paging tone sounds.
2 When the person at the handset presses I, the handset and base can
communicate without tying up the phone line.
3 Press again or press o on handset to disconnect.
On steadily:
handset or base
speakerphone is in use
Flashing slowly:
a call is on hold
Press to enter programming mode.
Press to return to idle state
1 Dial the number.
Use < to make
corrections.
2 Press d to
place the call.
91-5824-70-00_ATT1480_R0 9/15/03 2:47 PM Page 10