User`s manual

INSTALLATION

3 Charge the handset battery.

• Place the handset in the remote charging stand.

The CHARGING light goes on.

• Charge the battery at least 12 hours.

4 Check for dial tone.

• After the batteries are charged, lift the handset and

press P;you should hear a dial tone.

5 Set the time and date displayed on handset screen.

If you subscribe to Caller ID service, the date and time will

be set automatically with the first incoming call.

If you do not have Caller ID service, you can set the date

and time manually.

•Press G, then press > until DATE/TIME

is displayed. Press S.

• The month is flashing. Use < and > to select

the current month. Press S.

• The day is flashing. Use < and > to select

the correct day. Press S.

• The hour is flashing. Use < and > to select

the current hour. Press S.

• The minute is flashing. Use < and > to select

the correct minute. Press S.

• AM or PM is flashing. Use < and > to choose between

AM and PM.Press S.

6 Set the phone for tone or pulse dialing (base only).

•Press P on base.

•Press < or > until DIAL MODE:TONE is displayed,

then press S.

• Use < and > to select the correct setting.

•Press S to save the setting.

NOTE: Install the base unit and spare handset charger away from

electronic equipment, such as personal computers, television sets or

microwave ovens. Avoid excessive heat, cold, dust or moisture.

91-5824-70-00_ATT1480_R0 9/15/03 2:47 PM Page 8