430_book_2ATT-mk1(DEC21) 5/16/02 5:46 PM Page ii USER’S MANUAL Part 2 2.4 GHz Cordless Telephone with Caller ID/Call Waiting 1430 Please also read Part 1 — Important Product Information AT&T and the globe symbol are registered trademarks of AT&TCorp. licensed to Advanced American Telephones.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:46 PM Page iii © 2001 Advanced American Telephones. All rights reserved. Printed in China.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:46 PM Page v CONTENTS BEFORE YOU BEGIN ...............1 INSTALLATION ....................... 2 Before You Install.......................... 2 Table/Desk Installation ................. 3 Wall Installation ............................ 5 TELEPHONE DIRECTORY ......13 Store a Number/Name in the Directory ........................... 13 Edit a Number/Name Stored the Directory ........................... 14 Delete a Number/Name Stored the Directory .........................
1430_book_2ATT-mk1(DEC21) 5/16/02 5:46 PM Page 1 BEFORE YOU BEGIN Choosing a Location for Your Phone For best reception quality choose a location for the base unit of your new telephone: • away from microwave ovens • away from TVs,VCRs,stereo equipment and computers (Cordless telephones operate at a radio frequency that may cause interference with these types of equipment.) • away from extreme heat or cold.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:46 PM Page 2 INSTALLATION Before You Install 1 2 Choose a location for the base near an electrical outlet and a telephone jack. This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch. Install the handset battery. Use only the following AT&T Batteries 2414/2415:SKU#23403. a) c) Remove battery compartment cover by pressing on the indentation and sliding downward.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:46 PM Page 3 INSTALLATION 3 Attach belt clip to the cordless handset (optional). To attach To remove NOTE: Install the base unit and spare handset charger away from electronic equipment, such as personal computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture. Table/Desk Installation Standard electrical outlet Modular telephone jack 1 Connect the telephone line cord. 2 Connect the power cord.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 4 INSTALLATION 3 4 5 6 4 Charge the handset battery. Place the handset in the base. Charge the battery for at least 12 hours the first time. Check for dial tone. After the batteries are charged,pick up the handset and press ; you should hear a dial tone. Set the dial mode. If you have touch tone service,the phone is ready to use as soon as the batteries are charged. If you have dial pulse (rotary) service, you’ll need to change the dial mode.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 5 INSTALLATION Wall Installation 1 Connect the telephone line cord. 2 Connect the power cord. 3 Mount the base on the wall. Standard electrical outlet a) Align holes on base with mounting studs on wall jack. Modular telephone jack b) Pull base down on mounting studs until it locks into place. 4 Follow Steps 3–5 in Table/Desk Installation.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 6 HEADLINE TELEPHONELEFT OPERATION HEADLINE L-SUB Answer a Call Press any key except . Hold Press to put a call on hold. Press again to release hold — OR — Lift the handset of an extension. Make a Call Press , then dial the number — OR — Dial the number (use to backspace and correct digits),then press to call. Handset Volume While on a call, adjust volume of what you hear. End a Call Press — OR — Place handset in base. Exit programming. Cancel a page.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 7 TELEPHONE OPERATION If you subscribe to telephone company voice mail with a visual message waiting signal, light flashes when you have voice mail waiting. Flashes when you have unreviewed call information. Flashing: handset is in use. On steadily: handset is charging in base. Page/Handset Locator Press to page the handset for up to 60 seconds. Press again to cancel, or press on handset.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 8 TELEPHONE OPERATION Handset Ringer Style/Battery Save You can select from four dif ferent handset ringer styles,or turn the ringer off and extend the battery life. 1 Make sure the handset is off. 2 Press to enter programming mode. 3 Press until the screen displays . 4 Press . The screen displays the current setting. 5 Press or to select , , , , or . You will hear a sample of each ring. 6 Press to choose the displayed ringer setting.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 9 TELEPHONE OPERATION Operating Range This cordless telephone operates within the maximum power allowed by the Federal Communications Commission (FCC). Even so,this handset and base can communicate over only a certain distance — which can vary with the locations of the base and handset,the weather, and the construction of your home or office. For best performance, keep the base antenna fully upright.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 10 TELEPHONE MEMORY This cordless phone can store 10 telephone numbers with names,each up to 16 digits long in memory locations you assign (0-9). Note: Press at any time to exit memory dial mode. This cordless phone can store an additional 40 telephone numbers with names alphabetically in the director y. See TELEPHONE DIRECTORY for instructions. Store a Number/Name in Memory 1 2 3 Press . Then press until the screen displays . Press .
30_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 11 TELEPHONE MEMORY 5 6 7 8 9 When you finish entering the name,press or . The screen displays . Enter the telephone number. Use to backspace and make a correction. Press to store a pause in the dialing sequence. —OR— Press to display the last number dialed from this phone. Press or to store your entry. The screen displays and the current setting. Press or to change the setting.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 12 TELEPHONE MEMORY Delete a Number/Name Stored in Memory 1 2 3 Press . The screen displays . Press the memory location key of the entry you wish to edit. When the screen displays the number you want to delete,press . Then press or until flashes. 4 Press . The screen displays The current choice flashes. Press or until flashes. Press . 5 6 and the number. Dial a Memory Number 1 2 3 12 Press . The screen displays .
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 13 TELEPHONE DIRECTORY This cordless phone can store 40 telephone numbers with names,each up to 16 digits long. Entries are stored alphabetically. For consistency with Caller ID entries, you may wish to enter last names first. Note: Press at any time to exit directory. Store a Number/Name in the Directory 1 2 3 Press . The screen displays . Press . The screen displays .
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 14 TELEPHONE DIRECTORY 4 5 6 7 8 When you finish entering the name,press or . The screen displays . Enter the telephone number. Use to backspace and make a correction. Press to store a pause in the dialing sequence. —OR— Press to display the last number dialed from this phone. Press or . The screen displays and the current setting. Press or to change the setting.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 15 TELEPHONE DIRECTORY Delete a Number/Name Stored in the Directory 1 2 3 Press (DIR). The screen displays . Press or to scroll alphabetically through entries stored in memory —OR— Press the dial pad key for the first letter of the entry you want to delete. When the screen displays the number you want to delete,press . Then press or until flashes. PM 4 5 6 OLD Press . The screen displays and the number. The current choice flashes.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 16 CALLER ID OPERATION Caller’s name Caller’s telephone number Date of call Time of call Position of call in call history About Call History This phone assigns each incoming call a number from 1 to 99. The most recent call will have the highest number. When the memory is full,the oldest call information is deleted to make room for new incoming call information.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 17 CALLER ID OPERATION Delete Records from Call History Delete a Specific Call 1 2 Locate the record you want to delete from call history. Press , then press or until flashes. PM 3 4 5 OLD Press . The screen displays and the phone number. The current choice flashes. Press or until flashes. Press . You’ll hear a series of beeps confirming the deletion. Delete All Calls 1 While viewing call history, press flashes.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 18 CALLER ID OPERATION Store a Call History Record in the Directory 1 2 3 Locate the record in call history you want to store in memory. If you wish to change how the number is stored,press . The screen displays any alternate dialing sequences available for this call (area code + number; 1 + area code + number; 1+ number; number only). Press , then press or until flashes. PM OLD 4 Press three times to store the call record in memory without editing.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 19 BATTERIES Charge the Handset Battery Pack • This battery should remain charged up to six days with the ringer turned on and up to 10 days with the ringer off. A fully charged battery provides an average talk time of about 10 hours. • The battery pack needs charging when: — A new battery is installed in the handset. — The phone beeps twice every five seconds. — The screen displays and the low battery icon.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 20 BATTERIES Replacing the Handset Battery Pack 1 2 3 4 5 20 Remove the battery compartment cover on the handset by pressing on the indentation and sliding the cover downward. Lift out the old battery pack and disconnect. Align the two holes in the new battery pack’s plug with the socket pins,and snap the plug into place. Place the battery pack in the compartment with the wires in the lower left corner, along the bottom of the battery pack.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 21 IN CASE OF DIFFICULTY If you have difficulty operating this phone,try the suggestions below. For Customer Service,visit our website at www.telephones.att.com or call 1 800 222–3111. Please retain your receipt as your proof of purchase. If the phone doesn’t work at all, check these items first: • • • • • • • Make sure the AC adapter is plugged into an outlet not controlled by a wall switch.
1430_book_2ATT-mk1(DEC21) 5/16/02 5:47 PM Page 22 IN CASE OF DIFFICULTY If you hear noise or interference when using the phone: • • • • • • • Make sure the base antenna is fully upright. You may be out of range. Move closer to the base. Press and release to change to another of the 30 channels available. If noise is exceptionally loud,move closer to the base before changing channels. Household appliances plugged into the same circuit as the base can sometimes cause interference.
