- American Telephone & Telegraph USER'S MANUAL Cordless Telephone 1475, 1175

Table Of Contents

Getting Started

Belt clip & optional headset

Install belt clip as shown below if desired.

For hands-free telephone conversations, you can use any industry standard 2.5 mm

headset (purchased separately). For best results use an AT&T 2.5 mm headset.

Wall mounting

The speakerphone base can be installed on any standard wall-phone outlet as shown

below. Choose a location away from electronic equipment, such as personal comput-

ers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.

Rotate cradle up to hold handset upright

Plug power cord

transformer into

electrical outlet

Press and slide down firmly so

base is held securely on outlet

mounting pegs

Plug short line cord

into telephone jack

Snap belt clip into notches on

side of handset. Rotate and pull

to remove.

Plug 2.5 mm headset

into jack on side of

handset (beneath

small rubber cap)

Rotate antenna to

fully upright position

1 Use a flat-head screwdriver or coin

to turn the screw head to the unlock

position.

2 Rotate cradle up to hold the handset

upright when wall mounted.

3 Use a flat-head screwdriver or coin

to turn the screw head to the lock

position.