- American Telephone & Telegraph USER'S MANUAL Cordless Telephone 1475, 1175

Table Of Contents

Getting Started

Battery installation & charging

After installation, place the handset in the base and allow the battery to charge for 12

hours before use. You can keep the battery charged by returning the handset to the base

after each use. When battery power is fully depleted, a full recharge takes about 8 hours.

Press tab to open

battery compartment

Plug in battery here

Insert battery and

replace compartment

cover

Place handset in base to charge

for 12 hours before first use.

Charging light will be illuminated

while battery is charging.

Telephone base installation

Install the speakerphone base as shown below. Choose a location away from electron-

ic equipment, such as personal computers, television sets or microwave ovens. Avoid

excessive heat, cold, dust or moisture.

Plug power cord

transformer into

electrical outlet

Plug long line cord

into telephone jack

Low battery indicator

Return handset to base to recharge

when this symbol appears. (Handset

will beep when battery is low.)

NOTE:

Use only the power

cord supplied with this product.

If you need a replacement,call

1 800 222–3111.

Be sure to use an electrical outlet

not controlled by a wall switch.

Rotate antenna

to fully upright

position

NEW 00 OLD 27

0 8/12 10:06