User's Manual Chapter 13

The Indoor Unit has two telephone connectors, or jacks, as shown below: L1&2 and L2&1.

Indoor Unit Telephone Connectors

Note: The center pair of wires indicate the active line.

How do I connect a one-line telephone to Line 2?

Connect the telephone directly to the L2&1 jack on

the back of the Indoor Unit, if convenient, or to the

Line 2 jack of a splitter plugged into any wall

telephone jack. If you have any problems, contact

AT&T Digital Broadband Customer Service.

How do I connect a two-line telephone and have the Line 1 number

ring Line 1?

Connect the L1&2 jack on the back of the Indoor Unit to any wall telephone jack and

plug the two-line telephone into any other wall telephone jack in the house. If you have

any problems, contact AT&T Digital Broadband Customer Service.

Can I connect a two-line telephone to have the Line 1 number ring Line 2?

Yes, you can. Connect the L2&1 jack to a wall telephone jack. Calling the Line 1 number

will cause Line 2 to ring on any telephone plugged into the wall telephone jack in the

house. If you have any problems, contact AT&T Digital Broadband Customer Service.

Note: All customer-supplied equipment (such as telephones, modems, etc.) must

comply with FCC regulations, Chapter 47, Parts 2, 15, 24, and 68, regarding

attachment of equipment to the telephone network. Due to variances in the

manufacturer’s product design, some equipment may not work properly.

How do I reconnect the dual RG-6 cable to the Indoor Unit if it is

inadvertently disconnected?

Connect the lettered or ribbed side of the dual RG-6 cable to the “T” connector on the

back of the Indoor Unit as shown in this figure.

Customer Location Equipment Interconnection

The “T” connector on the back of the outdoor unit connects to the “T” connector on

the back of the indoor unit.The “C” connector on the back of the outdoor unit connects

to the “C” connector on the indoor unit.

How do the telephone connections work if I have three or four lines?

If you have three or four lines, you will have L3&4 and L4&3 jacks on the back of the

Indoor Unit.These jacks function identically to the L1&2 and L2&1 jacks for Line 1 and

Line 2, respectively. High-speed Internet access connectivity to your personal computer,

however, is available only on Line 1 and Line 2.

Note: You will lose phone service if you disconnect the dual RG-6 cable from the

Indoor Unit.

Indoor Unit

Line 1 & 2

Line 3 & 4

(Optional)

Surge Arrestor

Outdoor Unit

FPO FPO

Helpful Hints

AFWA20.CalifGuide w VM2d 11/22/00 12:01 PM Page 38