Specifications

Maintenance 3-13
13. Replace the top access cover.
14. Close the hood using proper procedures described in “Hood Opening/Closing Operation” of
the TC V3 Operations Manual.
To replace the bottom resistor:
1. Turn the power off by moving the Main Switch to the OFF position.
2. Open the hood to access the resistor.
3. Open the bottom access cover of the oven.
4. To remove the vitro-ceramic glass, on the inside of the oven unscrew the screw and remove
the clips from the maintenance part.
Figure 3-19 Maintenance Part Screw
Figure 3-20 Maintenance Part Clip
5. Repeat Step 4 for the other side of glass.
6. Carefully remove the glass.
7. To remove the resistor, unscrew the brides on each side and set aside.
Figure 3-21 Remove Vitro-Ceramic Glass
Figure 3-22 Bride Location
8. Remove the resistor and carefully replace with the new one.
9. Secure in place by re-installing the brides on each side.
10. Carefully re-install the vitro-ceramic glass.
Maintenance
Part
Screw
Maintenance
Part
Clip
Vitro-
Ceramic
Glass
Allen
Wrench
Screw
Brides
Resistor