Owner`s manual

14 Installation
Software Configuration
Once you have installed the pump on your dispensing system, the dispensing software must be configured.
WARNING! Only trained service technicians should perform this procedure.
1. Perform a system start-up as specified in the applicable dispensing system manual.
2. Start the Fluidmove software by double-clicking the Fluidmove icon
on the Windows
desktop.
3. Select Configuration > Setup Valves from the Fluidmove Main Window.
! The Setup Valves screen (Figure 3-16) opens.
Figure 3-16 Fluidmove Setup Valves
4. Select DV-Series for the DV-7000 valve or DV-8000 for the DV-8000 valve from the Active
Configuration list and click OK.
"NOTE For dispensing systems with a Dual-Action Dispensing Head, make sure Enable
Dual Valves is checked. You must configure the appropriate valve position (Valve 1
or Valve 2).
5. If the DV-7000/DV-8000 is equipped with a floating head, perform steps
a through e. If not, skip
to Step
6.
CAUTION! Enabling this feature on a valve that is not equipped with a floating head could result
in damage to the valve and to the workpiece.