User guide

6-28 Setup and Configuration
Dispensing System
Home Position
Origin of
Workpiece (0,0)
Workpiece Angle
Workpiece
Workpiece
x-axis
x-axis
Dispensing
System
y-axis
Dispensing
System
Defined pojnts along
Workpiece x-axis
Workpiece
y-axis
Figure 6-8
5. Click on Configuration.
6. From the Configuration menu, select Setup Fluid Manager to open the Fluid
Manager dialog box, shown in Figure 6-7.
7. Enter the information on the fluid you will be using for this tutorial (Hysol 4510 or
equivalent).
> The Pot Life should be documented in the material information data sheet.
> It is recommended that you disable Purge Maintenance for the tutorial
exercises. This means that the system will not automatically purge while in a
production run mode and will not purge during programming. Or, set the option
for over 900 seconds so that your programming runs are not interrupted by
automatic purging while running test programs.
8. Click on Save.
> FMW takes you back to the Main Window.
9. Click on Teach a Program.
10. Select File from the Programming Window menu.
11. Select Fluid Table, and then Save As.
> Save the Fluid File as a <filename>.flu file. You will attach this file to
your program later.
12. Click on OK.