User guide

Tour of Fluidmove 3-21
Figure 3-19
When you write a program in FMW, the file is stored as a <filename>.fmw file on the
hard drive of the computer or to a specified network drive. The last file saved is automatically
loaded upon FMW startup. Alternatively, a new file is selected from the list as shown in
Figure 3-19.
Fluid files, used to define the dispensing fluid characteristics, are attached to the program you
choose to run. Also, Heater files, which set your heaters, are attached to your file at this
dialog box.
è Choose Cancel to close the dialog box.
è Click on Setup to see the drop-down menu Setup options.
Fluidmove
Files are
FileName.fmw