User guide

Tour of Fluidmove 3-13
Process Toolbar
The commands associated with each icon in the Process Toolbar are identified below.
However, you will notice that FMW toolbars have Tool Tips. As you scroll the cursor over a
button, a “tip” appears below the button, explaining the function. If a button appears greyed-
out, that means that the command is not available at this point in the programming session.
The Wet/Dry Mode and Camera On/Off buttons are toggled to change between the two
modes.
Figure 3-11
Create a New
Program File
Open a Program
File
Save Current
Program
Print Current
Program
Wet or Dry
Run Mode
Unload a Board
Load a Board
Move Dispenser
to Home Position
Display Video
Purge Valve
Cut Program Lines
Copy Program Lines
Paste Program Lines
Run a Program
Pause Run after
Next Command
Stop Run at end
of Current Board
Run Program
in Steps
Abort Run
Return to Main Window
Access On-Line
Help
Measure Flow
Rate Command