User guide

Index - 2
heaters
controller, 4-2
heater control, 4-1
heater setup, 4-1
input offset, 4-6
loop names, 4-2, 4-3
manual mode, 4-3
needle heater, 4-1
output value, 4-3
set point, 4-3
temperature deviations, 4-8
thermocouple type, 4-6
time proportioning alarms, 4-8
height sensor, 3-2, 6-1, 6-10, 6-15, 9-5
height sensor micrometer, 6-12
–I–
I/O, 3-11
initialization, 3-2
installation, 1-1, 6-1, 6-6, 6-10, 6-15
Installation Package
Installation Guide, 2-1
Tutorial Board, 2-2
User Guide and Tutorial, 2-1
L
light levels, 3-1, 7-12
light source, 7-5
lines, 8-2
parameters, 8-10
weight control, 8-6, 9-3
–M–
manual conventions, iii
master offsets, 6-10, 6-15
measurements, 6-3
menu commands, 3-16
menu restrictions, 6-4
mid-move 1 and mid-move 2, 8-13
multi shot delta, 8-13
multipass, 9-1, 9-14
–N–
needle heater, 4-1
needle sensor, 6-10, 6-15
needle setup, 6-11
needle-to-camera offset, 6-19
needle-to-height sensor offset, 6-17
Notepad, 6-5
number of shot, 8-13
–O–
offsets
Calculate Master Offsets, 6-6
camera-to-height sensor, 6-19
needle-to-camera, 6-18
needle-to-height sensor, 6-17
Valve Offsets, 6-6
on-vector mode/off-vector mode, 8-13
operator level, 6-3, 6-4
Orthogonality Tolerance, 7-12, 7-14
–P–
part skipping, 3-2
passwords, 6-3, 6-4
pattern placement, 7-3, 8-23, 9-1
patterns, 7-3, 8-22
pot life, 3-24, 6-21, 6-24
potting, 8-21
preferences, 6-1
pre-move delay factor, 8-7
procedures, 7-3
process commands, 3-13
production, 3-20, 3-24, 10-4
production lot tracking, 3-2
program commands, 3-14
program groups, 3-3
programming, 3-12, 7-1, 7-3, 9-1
area fill, 8-21
encapsulation, 8-21
lines, 8-1
multipass, 9-1, 9-16
underfill patterns, 9-4
weight control lines, 8-6
programming setup, 6-21, 6-23
projection length, 7-13
prompted setup, 10-4
purge station, 3-2, 6-17
purging, 6-24
–R–
reticles, 6-8
retract acceleration, 8-8, 8-14
retract distance, 8-7, 8-14
retract speed, 8-8, 8-13
–S–
safe Z height, 6-10, 6-15, 6-18
scale, 3-10, 6-1
SECS/GEM interface, 3-6, 3-25, 5-1, 10-1
serial ports, 6-1
settling time, 8-13
setup